船用油水分离性测定器（JSH4401）

产品型号：

产品名称：船用油水分离性测定器（JSH4401）

产品说明：

JSH4401船用油水分离性测定器

一、符合SH/T0619标准

二、主要技术参数：

控温方式：进口数显温控仪自动控温

控温范围：常温~18℃

控温精度：±0.5℃

试验孔数：3孔

试样搅拌：3600±100r/min可调（数显计速）

计时方式：数显时间计时器

工作电源：AC220V±10%   50Hz

功    率：2 KW

外形尺寸：400×470×840＝长×宽×高（mm）

整机重量：28Kg

三、性能及特点：

1、本仪器采用进口温控仪自动控温，显示直观清晰，可满足18℃±2℃的温度需求，控温准确；

2、本仪器采用电热管加热和压缩机致冷，控温精度高，使用寿命长；

3、搅拌器马达的转速从3600±100r/min无级调速，采用传感器自动检测电机转速，并用数显表显示，转速稳定，直观；

4、本仪器采用数显计时器计时，到时自动报警，自动停止搅拌；

5、本仪器采用升降电机自动升降搅拌器。

6、本仪器在工作时可同时插入三支离心管，当一支搅完后，可旋转搅拌头圆盘，让电机搅拌第二支离心管内的试样，完后同样再搅拌第三支离心管内的试样

JSH4401 Marine oil-water separation tester

I. It conforms to SH/T0619 standard

Ii. Main Technical parameters:

Temperature control mode: Automatic temperature control with imported digital display temperature controller

Temperature control range: normal temperature ~18℃

Temperature control accuracy: ±0.5℃

Number of test holes: 3

Sample mixing: 3600±100r/min Adjustable (digital display speedometer)

Timing: Digital display time timer

Power supply: AC220V±10% 50Hz

Power rate: 2 KW

External dimension: 400×470×840 = Length × width × height (mm)

Machine weight: 28Kg

Iii. Performance and Characteristics:

1. The instrument adopts imported temperature controller to automatically control temperature, and the display is intuitive and clear, which can meet the temperature demａnd of 18℃±2℃ and the temperature control is accurate;

2. The instrument adopts electric heat pipe heating and compressor cooling, with high temperature control accuracy and long service life;

3. The speed of the agitator motor is stepless regulated from 3600±100r/min. The speed of the motor is automatically detected by the sensor and displayed by the digital display table.

4. The instrument adopts digital display timer to time it, which will automatically alarm and stop stirring;

5. This instrument adopts lifting motor and automatic lifting agitator.

6. Three centrifuge tubes can be inserted at the same time when the instrument is in operation. After one tube is stirred, the agitator head disk can be rotated so that the motor can stir the samples in the second tube, and then the samples in the third tube can be stirred again